Tripp Lite SMART3000RMOD2U Bedienungshandbuch PDF herunterladen (Seite 8)

4-5

USB and Serial Communication Connection

Use the included USB cable

and/or RS-232 DB9 serial cable

to connect

the communication port of a computer to the communication port of the UPS.

Install the PowerAlert software appropriate for the computer’s operating

system. Consult the PowerAlert manual for more information.

EPO Port Connection

This optional feature is only for those applications that require connection to

a facility’s Emergency Power Off (EPO) circuit. When the power module is

connected to this circuit, it enables emergency shutdown of the UPS system’s

output. Using the included cable

, connect the EPO port to a user-supplied

normally closed or normally open switch. The pin assignment for the EPO

port is shown in diagram

NOTE: The EPO port is not a phone line surge suppressor; do not

connect a phone line to this port.

External Battery Connection 

Your UPS comes with a robust internal battery system; external batteries are

needed only to extend runtime. Adding external batteries will increase recharge

time as well as runtime.

NOTE: Do not connect or disconnect battery packs when the UPS is

running on battery power.

The illustration (see

) shows the location of your UPS’s External Battery

Connector, where you will insert the battery pack cable. Complete installation

instructions for your battery pack appear in the battery pack owner’s manual.

Make sure that cables are fully inserted into their connectors. Small sparks may

result during battery connection; this is normal.

The Battery Configuration Port automatically detects up to four external

Tripp Lite battery packs and also estimates the remaining battery run time.

Using the included RJ-45 cable

, connect the Battery Configuration port to

a user-supplied Tripp Lite external battery pack.

NOTE: The Battery Configuration Port will only detect Tripp Lite

external battery packs that support this feature. To determine whether a

battery pack supports this feature, consult the battery pack owner’s

manual. Do not connect to a network.

Internal SNMP/WEB or Relay I/O Card Insertion

Remove the slot’s cover to install an optional internal SNMP/Web accessory

card (Model: SNMPWEBCARD) to enable remote UPS monitoring and

control via SNMP, Web or telnet. Contact Tripp Lite Customer Support at

(773) 869-1234 for more information, including a list of available SNMP,

network management and connectivity products. The accessory slot also

supports an optional Tripp Lite programmable UPS management device

(Model: RELAYIOCARD). This device that allows you to monitor UPS

status and events and perform remote system shutdowns and battery tests.

The following connections are optional. The UPS system will function properly without these connections.

Optional Installation

201112106 93-2729.indb 8 12/28/2011 3:44:08 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Tripp Lite SMART3000RMOD2U Bedienungshandbuch Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Unterbrechungsfreie Stromversorgungen (USVs) Tripp Lite SMART3000RMOD2U