Tripp Lite SmartRack SRCABLELADDER Bedienungsanleitung PDF herunterladen (Seite 4)

3-2 Ladder Modiﬁcation (Optional)

Warning: When using tools to cut or drill metal, use eye protection and follow all other safety precautions recommended by the tool

manufacturer and required by applicable safety regulations. Use caution and wear safety gloves when handling metal parts that have

been cut to length. Sharp edges can cause personal injury and property damage.

Note: Do not modify the SRCABLELADDER accessory unless you have followed the instructions in Section 3-1 Planning and determined that

modication is required. If modication is not required, proceed to Section 3-3 Ladder Assembly.

Measureandmarkthecableladdersectionthatwillbecut.

Useahacksaworothermetal-cuttingtooltocutthroughtheladdersection.Makesureyourcutisperpendiculartothelengthoftheladder

and use a metal-cutting tool that will not bend or crush the ladder section.

(Optional)Aftercutting,useadrillwitha3/8-inchbittodrillnewpinholesinendoftheladdersection.Comparethemodiedendofthe

laddersectionwiththeunmodiedendtodeterminewhereholesshouldbedrilled.Makesurethattheholelocationmatchesyourplanning

and measurements. You may omit this step, but drilling the pin holes and installing the pins will make the SRCABLELADDER accessory

more stable.

3-3 Ladder Assembly

Join the ladder sections

with two assembly brackets

inserting the brackets in the ends of the ladder sections.

Align the pin holes in the ladder sections with the pin holes in the

assembly brackets and insert clevis pins

into the pin holes

(4total).Note: The ladder sections should be ush for a standard

installation.

After inserting the clevis pins, insert a cotter pin

through the

holeattheendofeachclevispin.(Thestraightsectionofthe

cotterpingoesthroughthehole.)

ProceedtoSection 3-4 Installation Across Aisle or Section 3-5

Installation Within Row, depending on your application.

3 – Installation (continued)

1 2 3 4 5 6 7 8

Keine Kommentare

Tripp Lite SmartRack SRCABLELADDER Bedienungsanleitung Seite 4