Tripp-lite Modular UPS Systems SU16000RT4U Bedienungsanleitung PDF herunterladen (Seite 10)

Operation

The user can enter the Setup Mode at anytime (except during the Diagnostic Mode) by pushing both scroll buttons at the same time for more

than 1 second. The Setup procedure is as follows:

Startup Self-Test

When you turn the UPS ON, it will enter Diagnostic Mode and perform a self-test lasting about 15 seconds. The results of the self-test are

shown on the LCD screen in the sequences below.

DIAGNOSTIC MODE

FREQ OUT = XXHz

LCD Screen Message Sequence

(If UPS Is Started with AC Input)

DIAGNOSTIC MODE

FREQ OUT = XXHz

LCD Screen Message Sequence

(If UPS Is “Cold-Started” with No AC Input)

DIAGNOSTIC MODE

INPUT AC OK

DIAGNOSTIC MODE

INPUT AC BAD

DIAGNOSTIC MODE

BATTERY OK

DIAGNOSTIC MODE

BATTERY OK

DIAGNOSTIC MODE

CHARGER OK

DIAGNOSTIC MODE

AC/DC OK

DIAGNOSTIC MODE

AC/DC OK

DIAGNOSTIC MODE

TESTING INVERTER

DIAGNOSTIC MODE

TESTING INVERTER

UPS MODE

LOAD1 = XXX% X.XKW

ON BATTERY MODE

LOAD1 = XXX% X.XKW

Failed Self-Test

If a problem is detected during the self-test, the LCD will display an error message. If your UPS displays any of the following messages in its

LCD, call Tripp Lite Technical Support at (773) 869-1234 for service.

BAD BATTERY!

CALL FOR SERVICE

LCD Screen Messages

(If UPS Fails Self-Test)

CHARGER FAILURE!

CALL FOR SERVICE

AC/DC FAILURE!

CALL FOR SERVICE

INVERTER FAILURE!

CALL FOR SERVICE

OUTPUT FAILURE!

CALL FOR SERVICE

FAN FAILURE!

CALL FOR SERVICE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Tripp-lite Modular UPS Systems SU16000RT4U Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Tripp-lite Modular UPS Systems SU16000RT4U